Linksys Velop mesh setup
Velop nodes from different generations are not always compatible. Check the support article for the model on the node.
- Find the model on the node label before you open Linksys app.
- Connect only the primary unit to the modem or ONT. Leave satellites unplugged until the app asks for them.
- Create the network in Linksys app. Do not type the Wi-Fi password into MySpeedGauge.
- Pair one satellite nearby, update firmware, then move it using the floor planner.
- If the ISP gateway still routes, use bridge mode or access-point mode as that model’s guide describes.
Official Linksys Velop support
How this measurement works
Steps were reviewed 2026-11-01. They describe the shared part of an install. The official guide for your model wins when they differ.